Access Control , Telephone Entry, Entry Access, entry system, telephone entry systems, entry systems, telephone entry system
  |
Access Control, Entry Access
Systems for Commercial, Residential telephone entry applications. Call for expert advice from licensed installers. Contractors License NV. #57900 CA #363787 since 1978 Phone Hours (PST) 7:30 to 4:00 Mon.- Fri. |
The
AP-4 is a single door gate controller with a built-in radio receiver that
supports up to 339 transmitters that have a single entrance or gate, the AP-4 is
the ideal wireless-based access control system. It can be used to remotely
activate devices such as gate operators, door strikes, or door operators. Based
on the proven AP-1, AP-2 and AP-3 access controllers, the AP-4 is small enough
to be mounted within the gate operator. The AP-4 has a built-in radio receiver.
It has a 250 foot range that can be extended even farther with an optional
EXA-2000 antenna. Two relay outputs are provided: one for gate or door access;
the other for obstacle control using the MGT, the industry’s only supervised
safety edge transmitter. The AP-4 looks for an hourly status transmission from
the MGT to report on transmitter functionality, battery condition, and case
integrity. If any of those conditions require attention, the AP-4 will alert the
user by beeping once every five seconds. The user must then activate the
transmitter twice in order for the AP-4 to grant access. Installation and set-up
are simple. The AP-4 operates on 12-24 volts, ac or dc. It can be powered
directly from the radio power output of most gate operators. Learning,
suspending, or deleting transmitters is as simple as pressing few keys on the
AP-4’s built-in keypad. Program data is stored in non-volatile EEPROM; data
retention is in excess of ten years, even in the event of a power failure. The
AP-4 is compatible with all MegaCode format transmitters, which come factory
programmed with one of over 1,000,000 possible codes, all but eliminating any
chance of duplication